Defining and understanding pitch versus pitch class.Understanding the staff (staves) and the Grand Staff.Understanding the use of clefs.Understanding the use of ledger lines.

You are watching: The highness or lowness of a sound is called?

Pitch is defined as the relative highness or lowness of sound. This is a general definition: in music we speak of pitch as a specific tone that is specifically placed and notated. Pitch-class, a relatively recent term, describes a generalized or generic relationship of pitches that sound essentially identical but are separated by a sense of highness or lowness. Pitch-class also refers to tones that share the same “pitch-space,” that is, they sound identical, but are “spelled” differently.

The Staff

Since early notation was not specific as to exact placement of pitch, a system of parallel horizontal lines came into use in order to show exact placement.Interestingly, earlier systems of notation employing parallel lines had been in use. Many used only the lines themselves to locate pitch, not the spaces between. This staff originated as a system of eleven parallel lines that encompassed the theoretical span of available pitches, which was the range of the male voice from Bass to male Soprano.In St. Paul’s Epistle to the Corinthians he delivers an injunction to “Let your women keep silence in the Church…” This became the rationale for the exclusion of women from participation in the early church. In practice, this complete system was limited to four or five parallel lines encompassing the range of a given chant melody or voice part.

Figure 2.1 The Guidonian Staff

Pitches were assigned specific names. The lowest pitch, called gamma, extended to the highest pitch, ut: the contraction of these two terms, gamut, has entered the language to mean “a complete range or scope.”

The eleven-line system is visually cumbersome. In early music specific lines were colored with different dyes, each line locating a specific pitch. All other pitches were held in relation to these. In time, the eleven-line staff was separated into two five-line staves. The remaining line between the two staves was not drawn, but was understood as being “shared” by each staff.

Specific symbols came into use, replacing the colored lines. Clefs (French-“key”) served the same purpose as colored lines, locating exact pitches around which all other pitches were calculated. These clefs represented general voice ranges and their names reflect this.

We label pitch-classes by the use of letter-names. Other labels are discussed in Section 2.2 "Chromatic Alteration: Accidentals". The Treble Clef (or “G-clef”), nominally indicating a high voice, locates the pitch “G” on the second line up on the staff.

The Bass Clef (or “F-clef”) locates the pitch “F” on the fourth line up on the staff. From these two fixed points, all other pitches were calculated and placed on the five-line staff. Figure 2.2 shows the Treble and Bass Clefs and pitch placement on lines and spaces.

Treble and Bass Clefs, The Grand Staff

Figure 2.2 Treble Clef and Staff; Bass Clef and Staff

These two staves are combined into a system called The Grand Staff.In notation we call complete lines of music a system. This reflects its origins from the Guidonian staff: two five-line staves, slightly separated, the remaining invisible middle line shared by both. The Grand Staff now yields the potential for locating and notating all pitches, from lowest to highest.

Figure 2.3 The Grand Staff

In Figure 2.3 pitches are listed just outside the boundaries of each clef on the Grand Staff. Since the two staves (Treble and Bass) are separated from one another in the Grand Staff, it is necessary to use symbols to extend each beyond its five-line boundaries.

Ledger Lines

Short horizontal dashes are used to extend the range of either staff, above or below. These dashes, called ledger lines, serve as truncated staff lines. They may occur above or below a notehead, or they may bisect a notehead.

Figure 2.4 Ledger Lines

The student should exercise particular care when drawing ledger lines. A common mistake of nascent music students is placing the ledger line on the wrong side of the notehead. When drawing notes observe several other properties:

Stems extend up or down from the notehead to the next pitch-class of the same name.This practice for notating stem length has its early origins as a pitch designation, not as a durational value.Stems are drawn down from noteheads on the middle line of the staff and above. Below the middle line, stems are drawn up.In extended passages across the middle line of the staff, stems may be the same direction. There is no rule for this: it is a matter of visual uniformity.For stems up: the stem is always on the right side of the notehead. For stems down: the stem is always on the left side of the notehead.Stem placement has not always been uniform. When studying scores of earlier music, one will readily observe that stem placement in relation to the notehead seemed to be a matter of choice, style, or convenience

Pitch Placement on the Staff

Using these notational devices and practices, exact pitch placement can be shown. Note that the pitch that is one ledger line above Bass Clef is identical to the pitch that is one ledger line below Treble Clef (both are “Middle C”). This shared, connective pitch is reminiscent of the middle line from the Guidonian staff and serves to connect the two staves.

How To Adjust Clutch On Ez Go Golf Cart Clutch? Having Trouble With Your Golf Cart Clutch

On the example provided, practice drawing Treble and Bass Clefs.